濟南油煙凈化器在工作中經常會出現一些故障。比如高壓電場跳閘保護等。一些非技術性的故障問題我們可以通過檢測判斷故障原因，來自己進行解決。下面就為大家詳細介紹這個故障的相關信息。

Jinan oil fume purifier often has some faults in its work. Such as high voltage electric field trip protection. We can solve some non-technical fault problems by detecting and judging the fault causes. The following will give you detailed information about this fault.

（1）電場短路

(1) Electric field short circuit

故障原因：①在安裝時不小心使陰極針歪。②在清洗后電場內殘留有雜物。

Fault cause: ① the cathode needle is crooked due to carelessness during installation. ② Sundries remain in the electric field after cleaning.

解決方法：①拆下電場，校正陰極針。②電場內的雜物。

Solution: ① remove the electric field and correct the cathode needle. ② Remove sundries in the electric field.

（2）絕緣子短路

(2) Insulator short circuit

故障原因：清洗時絕緣子上殘留有過多的清洗劑。

Fault cause: too much cleaning agent remains on the insulator during cleaning.

解決方法：將絕緣子清洗干凈。

Solution: clean the insulator.

（3）高壓變壓器損壞

(3) High voltage transformer damaged

故障原因：聽不到靜電聲，檢查電場沒有短路，而且一開機即跳閘或燒保險管。

Fault cause: no static sound can be heard. Check that there is no short circuit in the electric field, and it trips or burns the fuse tube upon startup.

解決方法：更換高壓變壓器。

Solution: replace the high-voltage transformer.

（4）變壓器超溫

(4) Transformer overtemperature

故障原因：由于廚房環境溫度過高，通常是設備工作到高峰時跳閘。

Fault cause: due to the high ambient temperature in the kitchen, the equipment usually trips at the peak of operation.

解決方法：引入鮮風對油煙凈化設備進行強制降溫。

Solution: introduce fresh air to forcibly cool the oil fume purification equipment.

（5）可控硅損壞

(5) Thyristor damaged

故障原因：此故障表現為電場只放電一次就跳閘保護或燒保險管。

Fault cause: this fault is shown as tripping protection or burning of fuse tube when the electric field is discharged only once.

解決方法：更換相同型號的可控硅。

Solution: replace the thyristor of the same model.

油煙凈化器出現的高壓電場跳閘保護故障原因解決就是上述所講解的內容這樣了，當然如果您在使用之前提前做好了預防措施，那么后期就會很少出現問題了，更多內容就來我們網站http://m.babellg.com咨詢吧。

The reason for the high-voltage electric field trip protection fault of the oil fume purifier is the content explained above. Of course, if you take preventive measures in advance before use, there will be few problems in the later period. For more information, please visit our website http://m.babellg.com Consult.